AUKTools NVR Switch With UK Plug

An industrial-quality NVR Switch made exclusively for Wood Workers Workshop to run on a UK and European 230v domestic power supply. Fully wired with a BS three-pin plug.

Safety First!

• Take control – no more scrambling under the table trying to find the on/off switch for your router – operate the router’s on/off switch from your remote controller unit
• Can be used as remote switching and isolation on a range of power tools including Lathes, Pillar Drills, Dust extractors
• NVR (No Volt Release) switch – this means that if you suffer power loss, your router will not restart until you manually switch it back on
• The emergency stop button locks on and can only be released when you physically twist to unlock it – allowing you to isolate your router whilst you change cutter.
• Locate your remote controller unit wherever suits you – on the wall; on the side of your router table …
• Plenty of cable to play with – 1.2 metres between the BS1363/A Socket and the remote controller unit, plus 2.7 metres between the remote controller unit and the power supply
• Particularly useful to owners of the INCRA Clean Sweep box and Insert Rings as the fully enclosed router is now controllable outside the box

Technical Specification

• Size 80 x 115 x 96mm deep
• 13A switching up to 3.1 KW maximum load capacity
• Separate off and emergency isolating off buttons
• Isolating emergency stop button with twist release
• Double pole NVR isolator
• Simple plug and play
• Groundbreaking 3.9 meters total cable length for maximum flexibility
• High-level IP 54 rated for protection from dirt, dust and splashing water